The working principle of garlic peeling machine:
Dry-type garlic peeling machine uses compressed air as the production power, through the use of special design peeling principle, peeling process, garlic
The flaps are completely free from the razor blade and hardness rubbing, so that the garlic peels naturally, to ensure that the garlic is not damaged, the surface is smooth, No.
With pollution, the garlic can be automatically guided, peeled and discharged automatically by electricity and gas control.
The characteristics are as follows:
1. Adopt the special design of peeling principle, peeling process, garlic flaps completely without the blade and hardness friction, to ensure
Garlic has no damage, smooth surface and no pollution. This equipment is practical, electricity saving, high efficiency, maintenance and cleaning.
Easy, low failure rate and so on.
2. With an automatic feeding device, the garlic kernel and garlic peel can be separated automatically. The product meets the hygienic standard and can be stored because the garlic kernel is not easy to be damaged.
The advantage of many days is that the equipment is sold both at home and abroad, and is well received by customers.
Four, cleaning and maintenance
If the desquamation effect is found to be decreased during the operation, the desquamation bucket should be removed and cleaned to maintain a high desquamation rate, and clean at the same time.
Wet rag to clean dirt on inlet baffle, cylinder shaft and discharge baffle.
(1). 将脱皮桶放在水桶里倒入温水浸泡 一会,使其内的渍垢融化用湿布将其 擦洗干净,并且时常检查 8 根脱皮管子是否全部通气,不然会影响脱皮效果。以干净的湿抹布彻底擦亮入料桶，严禁残留蒜油碎屑在其轴心上,以免影响入料量不均匀,
(1) Put the peeling bucket in the bucket and soak it in warm water for a while, so that the dirt in the bucket will melt and wipe it clean with a wet cloth, andAlways check whether the 8 peeling tubes are completely ventilated, otherwise the effect of peeling will be affected.Clean wet cloth is used to clean the barrel thoroughly. It is forbidden to leave garlic oil fragments on its axis, so as not to affect the uneven feeding quantity.
The result is that the peeling effect is bad. Meanwhile, check whether the fixing screws of the feeding baffle are loose or not, and should be tightened in time.
(2) 每过几天应打开集料桶,取下内部网筛,将蒜屑清理并集中由下料口排出. 网筛清理内壁四周。
(2) Every few days should open the aggregate barrel, remove the internal screen, garlic chips will be cleared and centralized from the outlet discharge. Screen cleaning the inner wall around.
These are the features of the slicer we introduced. I hope our introduction can help you. If you don't understand anything, please contact us at www.hsbrewards.com.